The main thing to remember is when temperatures fall into the 40°'s and 30°'s, spray paints, inks and crayons take much longer to dissolve.
When working withBare Brick Stone & Masonry Graffiti Removeror Sensitive Surface Graffiti Remover, dwell times sometimes need to be 2-3 times longer to yield the same results. It's often helpful to leave your remover on much longer than that before rinsing.
It also helps to keep our products indoors and even inside the car before applying them, so they are at room temperature when you're ready to use them.
During the winter months we will sometimes applyBare Brick Stone & Masonry Graffiti Removerseveral times and then leave Transgel on over the top for hours or even overnight before pressure washing. This will keep the graffiti wet much longer and make it easier to rinse completely the first time. Transgel eats through all the thicker bits of graffiti crinkling it up, while Bare Brick penetrates and dissolves it from behind.
Of course, pressure washing in freezing conditions is a tricky exercise and we recommend reserving larger projects for the Spring if that is an option.
For signs, trucks, trailers, and other sensitive surfaces, you may need to leave Sensitive Surface Graffiti Remover on for several minutes before coming back to agitate and wipe away. Sometimes lightly abrading the surface with a soft scourer between coats will help the remover penetrate and begin dissolving it faster.
Hot Tips! A hot water pressure washer/steam cleaner makes a HUGE difference in graffiti and paint removal. Sometimes you might want to spray a wall down first in order to heat up a section of graffiti before removing it. Our friends at NYC Power Wash suggested filling up a bucket with hot water, and leaving the bottle of product in it so that it warms up before use.
Clips Courtesy of NYC Power Wash
3 Golden Rules
1) If graffiti is not coming off easily, you're doing it wrong. You may require a change of tact or use of another product.
2) If you can't remove a little bit of graffiti, then you're not going to remove a lot. TEST FIRST before applying product to an entire job. This way you can determine if you’re on the right track before embarking on full scale removals.
3) If you're working hard, you're doing it wrong. Forget the scrubbing, blasting and any other abrasive measures. Put simply, either your products are working or they’re not. Any problems can be taken care of with the right technique.
Share this Article
Click on any of the icons below for how-tos & more